Gun Cleaning Information

Gun Cleaning Information

Step 1
Scrub out your gun bore with the right measurement Phosphor bronze brush and use Bor-Solv supreme bore solvent. This will if used vigorously remove all powder fouling and residue. Often a Bristle brush may be desirered as being made of natural hair it is hydroscopic. This truth will help this brush retain more of it's bore solvent chemical and for an extended period. In some applications a bristle brush can due to this fact be an enchancment over a phosphor bronze brush. This technique however, is now more commonly utilized in Europe.

Step 2
After scrubbing out utilizing each sides of a Herringbone 4"x 2" patch in a Cut up brass or Nylon jag. This will remove all the contaminated solvent. The cut up jag is utilized by inserting a patch midway and longitudinally into the split after which rotating the patch in your hand in the direction you'll tighten the patch and in addition twist the rod in use. All the time check the chamber when cleaning and if there may be powder residue across the forcing cone use a Chamber brush handle with a Payne Galway chamber brush to remove residue build up.

Step three
Next oil the gun bores through the use of a clear Wool mop and some liberally utilized Rangoon oil. Rangoon being a tenacious and sluggish evaporating oil permits the gun bore to be stored away for longer durations than usual. Sometimes wash out the wool mop with warm soapy water. Use paraffin or turps first if the mop could be very dirty. Then when the mop is dry re-soak in clear Rangoon oil and we suggest you keep the mop in a contemporary polythene sleeve or comparable container.

Step four
When storing your gun don't forget to first relieve the tension of the main springs by inserting a suitable pair of Snap caps and dry firing the gun. Then after when you set up a Muzzle stuffer this will with the snap caps in place not only hold the oil vapour inside the barrel, but may also keep the dirt out and defend the top of the barrels against damage in your gun cabinet

Step 5
Earlier than firing the gun again you will need to remove all hint parts of oil. Oil remaining in the barrel nevertheless slight might critically rival the barrel walls as a consequence of hydraulic conversion process. Remove all superfluous oil with a patch and jag turning the patch over till it is clean. Always check the chamber before firing and if there may be powder residue across the forcing cone remove it with a chamber brush. We advise you by no means to force a Payne Galway type chamber brush down the barrel as this type of brush will ultimately come aside and may damage the gun.

Ideas and Final Word...
When cleaning a rifle cleaner or pistol use the same method as for a shotgun besides change the split brass jag for a Diamond jag and change patch to the pure flannel type Rifle patch. To make use of the diamond jag place the jag diagonally throughout the patch at the end and rotate till the patch has wound absolutely across the jag. If the patched jag is simply too massive for the bore in diameter, unroll just a little of the patch at a time, trim and rewind similar until the correct interference diameter is obtained. When cleaning proceed to change the patches until the final patch discarded is solely clean.

Lastly we'd provide this good advise. Never be tempted to use a set of Gunmakers Turnscrews unless you might be absolutely positive that the Turnscrew blade has been precision ground to the precise size of the slot in your gun screw and the device metal is properly hardened. Engraved gun screws are very costly to repair and the wrong sized blade can in a short time cam out of the screw in question and will damage the gun screw or the end on the gun. In some cases even injury to the user can occur. If you're not sure at all times ask you gun supplier for advise. If you must use a turnscrew on your gun make your that it's of good producer not a cheap and poorly made import.